New Tank and Fittings
We supply a Rheem, A. O. Smith, or Bradford White tank in 40, 50, or 75 gallons, plus new dielectric unions, flexible connectors, Teflon tape, and pipe dope on every threaded joint.
Same-day hot water restoration across Carroll County
Emergency Water Heater Replacement in Carrollton
When your tank splits at 2 a.m. or your pilot light quits before Thanksgiving, Emergency Water Heater Replacement in Carrollton gets hot water back the same day. We stock Rheem, A. O. Smith, and Bradford White units for 40, 50, and 75-gallon swaps, handle the gas or electric hookup, and haul the old tank away. One call covers Carrollton, GA and all of Carroll County.
Careful work. Honest options.
About this service
What Emergency Water Heater Replacement in Carrollton Involves
Emergency Water Heater Replacement in Carrollton means pulling a failed tank and setting a new one on the same visit, not scheduling a repair for next week. We kill the gas or breaker, drain the tank with a pump, cut out the old copper or PEX, and set the new unit on fresh dielectric unions and flexible connectors. A T&P valve, expansion tank, and drip leg go on before we open the valve. Most swaps run two to four hours from arrival to hot water.
Carrollton homes built before 1990 still run original 40-gallon tanks with sediment an inch deep, and the hard water off the municipal supply eats anode rods fast. When a tank starts leaking or the heating element fails, you do not have days. We run 24/7 emergency water heater replacement Carrollton calls across Carroll County, including same-day emergency water heater installation Carrollton Georgia for rentals and multi-unit buildings that cannot wait.
- ✓ Same-Day Hot Water
- ✓ Code-Correct Hookups
- ✓ Flat-Rate Pricing
- ✓ Old Tank Hauled Away
What's included
What Our Emergency Water Heater Replacement Includes
Every emergency replacement covers the full swap, not just the tank. We handle the disconnect, the new install, the code items, and the cleanup. Add-ons like a tankless conversion or a gas line upgrade are quoted separately before we start.
T&P Valve and Expansion Tank
A new temperature and pressure relief valve goes on every install, along with an expansion tank sized for your home. We test the valve before we leave so it does not weep.
Gas or Electrical Hookup
Gas units get a new flex connector, a drip leg, and a leak check at every joint per NFPA 54. Electric units get a new whip and a check of the breaker and wire gauge.
Old Tank Removal
We drain the old unit with a pump, disconnect it, and haul it out of the closet. The tank gets recycled, and you do not pay a separate disposal fee.
Permit and Inspection
We pull the Carroll County permit and meet the inspector on site. The install is done to Uniform Plumbing Code and International Plumbing Code so it passes the first time.
Startup and Walkthrough
We fill the tank, purge the air, and confirm hot water at the tap. You get a walkthrough of the shutoff, the anode rod, and the thermostat setting before we pack up.
How it works
Our Emergency Replacement Process
We answer 24/7 and ask three questions: gas or electric, tank size, and whether water is actively leaking. That tells us which Rheem or A. O. Smith unit to load and whether to bring a drain pump. You get an arrival window in minutes, not hours.
Our licensed plumber checks the T&P valve, anode rod, heating element, and thermostat with a multimeter. If the tank is sound, we repair. If the tank is leaking or the flue is compromised, we quote a full replacement on the spot. Diagnosis takes 15 to 20 minutes.
We shut the gas or breaker, connect the drain pump, and empty the tank. Copper pipe gets cut with a tube cutter; PEX gets a clean slice. We cap the gas line, remove the old flex connector, and set the tank on a dolly for removal.
The new unit goes in on brass fittings, Teflon tape, and pipe dope. We solder copper or crimp PEX, install a new expansion tank and T&P valve, and pressure-test every joint. Gas units get a drip leg and a leak check at each connection.
We fill the tank, purge air from the lines, and fire the burner or flip the breaker. You get hot water at the tap before we pack up. We show you the anode rod location, the shutoff, and the thermostat setting so you can maintain it.
STEP 01Phone Triage
We answer 24/7 and ask three questions: gas or electric, tank size, and whether water is actively leaking. That tells us which Rheem or A. O. Smith unit to load and whether to bring a drain pump. You get an arrival window in minutes, not hours.
Tools & methods
Tools and Methods We Use
Pipe Wrench and Tube Cutter
Used to break loose old unions and cut copper pipe cleanly so the new tank sits on fresh fittings without a torch near the wall.
Soldering Torch and Flaring Tool
For copper sweat joints and gas flare fittings. We solder with lead-free solder and flare gas lines to the size the unit requires.
Water Heater Drain Pump
Empties a 50-gallon tank in about 10 minutes instead of an hour of gravity draining, so the swap moves faster and the floor stays dry.
Multimeter and T&P Valve Tester
Checks the heating element, thermostat, and upper and lower elements on electric units, and confirms the relief valve opens at the rated pressure.
Expansion Tank and Dielectric Unions
An expansion tank absorbs thermal expansion and protects the T&P valve. Dielectric unions stop galvanic corrosion between copper and steel.
Gas Flex Connector and Leak Detector
A new flex connector goes on every gas install, and we check each joint with a leak detector before we light the burner.
Real results
Before and after.
Emergency Water Heater Replacement
Leaking 40-Gallon Tank in Downtown Carrollton
A 12-year-old gas tank started dripping from the base on a Friday night. Water was running into the hallway and the closet floor was soaked. The homeowner shut the supply valve and called us at 9 p.m.
After: We arrived by 10:15 p.m., drained the old tank, and installed a new 50-gallon Rheem with a drain pan and new expansion tank. Hot water was running by 12:30 a.m., and the old tank was recycled the next morning.
Book this service →
Emergency Water Heater Replacement
Rusty Water in a Castle Hills Home
The family noticed rusty water and popping noises from a 10-year-old A. O. Smith tank. The anode rod was gone and sediment had built up an inch deep on the burner. A leak was weeks away.
After: We replaced the tank with a new A. O. Smith unit, added a fresh expansion tank, and flushed the lines. The water ran clear the same afternoon, and the gas bill dropped about 8 percent the next month.
Book this service →
Emergency Water Heater Replacement
No Hot Water in a Trinity Mills Rental
A tenant called on a Sunday with no hot water. The electric tank was 14 years old, the lower element had failed, and the breaker kept tripping. The property manager needed it fixed before Monday.
After: We installed a new 40-gallon electric unit on a dedicated circuit, replaced the whip, and tested the breaker. The tenant had hot water by Sunday evening, and the invoice went to the property manager the same day.
Book this service → Problems we solve
Problems We Solve with Emergency Water Heater Replacement
A failed tank rarely fails quietly. These are the calls we run most often in Carrollton, and how we get you back to hot water fast.
Ask a pro →Leaking tank flooding the closet or garage
We shut the supply, drain the tank with a pump, and install a new unit with a drain pan and line. The old tank is hauled away, and we dry the closet floor before we leave.
No hot water after the pilot light goes out
We test the thermocouple and gas valve. If the tank is sound, we replace the thermocouple. If the tank is cracked or the flue is compromised, we install a new gas unit the same visit.
Rusty water and popping noises from sediment
We confirm the tank condition, then swap in a new unit with a fresh anode rod and a flush. We show you how to drain a quart of water every few months to keep sediment down.
Failed heating element or tripped breaker
We test the element and thermostat with a multimeter. If the tank is otherwise sound, we replace the element. If the tank is old or the liner is compromised, we install a new electric unit on a dedicated circuit.
Transparent pricing
What Emergency Water Heater Replacement Costs
$850 - $2,400 depending on tank size, fuel type, and venting
Typical 2026 pricing for emergency water heater replacement in Carrollton runs $850 to $2,400. A standard 40-gallon gas swap with a like-for-like vent sits near the low end. A 75-gallon power vent unit, a tankless conversion, or a closet that needs copper rework pushes toward the top. The quote includes the tank, labor, permit, and old-unit disposal. We give you the number before we cut a pipe, and it does not change when the closet door opens.
A failed tank can cause $3,000 or more in water damage if it floods a finished floor. Paying for a same-day swap protects the closet, the drywall, and your schedule. The new unit also cuts gas or electric use compared to a sediment-clogged tank.
•affects cost
A 40-gallon gas tank costs less than a 75-gallon electric or power vent unit. Tankless and hybrid heat pump units cost more because the venting and electrical work changes.
Get a quote ↗•affects cost
If the existing flue does not meet NFPA 54, we redo it. A larger gas line for a 75-gallon or tankless unit adds labor and materials to the job.
Get a quote ↗•affects cost
A tight closet, a missing drain pan, or a T&P discharge pipe that ends in the wrong place adds time. We quote those items upfront instead of billing by the hour.
Get a quote ↗•affects cost
Overnight, weekend, and holiday calls carry the same flat rate as a weekday. Winter freeze events can add a trip charge if we have to thaw a line before the swap.
Get a quote ↗ Proof you can check
Licensed, Insured, and Warrantied
- Georgia Plumbing License · Georgia State Construction Industry Licensing Board
- Uniform Plumbing Code (UPC) Compliance · International Association of Plumbing and Mechanical Officials
- NFPA 54 Gas Code Compliance · National Fire Protection Association
- Manufacturer Certification (Rheem, A. O. Smith, Navien) · Respective manufacturers
- OSHA Safety Compliance · Occupational Safety and Health Administration
Customer reviews
Reviews from Carrollton Customers
★★★★★
“Our 12-year-old tank let go on a Friday night and water was running into the hallway. I called at 9 p.m. and a plumber was here by 10:15. He drained the old unit, set a new 50-gallon Rheem, and had hot water running before midnight. The price was exactly what he quoted on the phone.”
MT
Marcus T.Homeowner, Downtown Carrollton
✓ Verified“
★★★★★
“I manage four rentals near Trinity Mills and a tenant called with no hot water on a Sunday. The crew swapped a 40-gallon electric tank in about three hours and sent me the invoice the same day. They even hauled the old tank off. I have used them twice since.”
DR
Dana R.Landlord, Trinity Mills
✓ Verified★★★★★
“Rusty water and popping noises told me the tank was done. They came out, confirmed the anode rod was gone, and installed a new A. O. Smith unit with a fresh expansion tank. They walked me through the thermostat setting and left the closet cleaner than they found it.”
KS
Kevin S.Homeowner, Castle Hills
✓ VerifiedMost Carrollton emergency water heater replacements run $850 to $2,400 in 2026. A standard 40-gallon gas swap with a like-for-like vent sits near the low end. A 75-gallon power vent unit, a tankless conversion, or a closet that needs copper rework pushes toward the top. The price includes the tank, labor, permit, and old-unit disposal.
We do. Carrollton Water Heater Replacement Pros dispatches licensed plumbers across Carroll County 24/7. We cover Downtown Carrollton, Trinity Mills, Rosemeade, Josey Ranch, and the ZIP codes 30117, 30116, and 30118. One call to (943) 469-0029 gets a stocked truck rolling to your address.
Most calls get a plumber on site within 60 to 90 minutes, and the swap itself takes two to four hours. If you call before 6 p.m., you usually have hot water the same night. Overnight calls in Carrollton, GA are handled the same way, with the same flat-rate pricing.
Yes. We answer the phone at 2 a.m. on a Sunday and dispatch the same crew that works weekdays. Weekend and holiday calls carry the same flat rate as a Tuesday afternoon. A leaking tank does not check the calendar, so neither do we.
Ready when you are
Need Emergency Water Heater Replacement in Carrollton Tonight?
We answer 24/7 and dispatch a licensed plumber with a stocked truck. Flat-rate pricing, same-day installs, and old-tank haul-away included. Call now and get hot water back before morning.
Call Now (943) 469-0029 →
Request an appointment
Call for Water Heater Help
Reach us at (943) 469-0029 any time, day or night. We answer live, ask a few questions about your tank, and get a plumber headed your way. Regular appointments run Monday through Friday, and emergency calls are covered 24/7 across Carrollton and Carroll County.
Call anytime(943) 469-0029Email the officeinfo@waterheaterreplacementcarrolltonga.xyz
Office hoursOpen 24 hours · 7 days a week