Old Tank Removal
We drain the old unit with a water heater drain pump, disconnect the gas or electrical supply, and haul the tank away for proper disposal. No rusty unit left behind for you to deal with.
Licensed plumbers, same-day service, and code-correct installs across Carroll County
Residential Water Heater Replacement in Carrollton
When your tank starts leaking or the hot water quits, Residential Water Heater Replacement in Carrollton gets you back to normal fast. We handle residential water heater installation in Carrollton for homeowners in Downtown, Hebron, Castle Hills, and every neighborhood in between. Our licensed plumbers pull the old unit, dispose of it, and set a new one the same day in most cases, so you are not stuck waiting.
Careful work. Honest options.
About this service
What Residential Water Heater Replacement in Carrollton Involves
Residential Water Heater Replacement in Carrollton is the full removal and reinstallation of a home's water heating unit, covering the tank, connections, venting, and safety controls. We drain the old tank, disconnect the gas or electrical supply, cut out corroded fittings, and install a new unit sized for your household. That means new dielectric unions, flexible connectors, a fresh T&P valve, and an expansion tank where code requires one. Most jobs take two to four hours from arrival to hot water.
Carrollton homes deal with hard water and temperature swings that wear tanks out faster than the national average. Sediment buildup on the heating element, a corroded anode rod, and popping noises are the usual warning signs. If you are searching for residential water heater replacement near me, we cover the whole city and Carroll County. We also handle the cost to replace residential water heater in Carrollton GA questions upfront, so you know the number before we start.
- ✓ Same-Day Hot Water
- ✓ Code-Correct Installation
- ✓ Lower Energy Bills
- ✓ Old Tank Hauled Away
What's included
What Our Residential Water Heater Replacement Includes
Every replacement covers the full removal, installation, testing, and disposal. We tell you upfront if your job needs a permit, a venting change, or an expansion tank so there are no surprises on the invoice.
New Unit Installation
We set the new tank, connect copper pipe or PEX tubing with brass fittings, and seal every thread with Teflon tape and pipe dope. Dielectric unions prevent corrosion at the connections.
Safety Component Testing
Every install includes a new T&P valve and a charged expansion tank where code requires one. We test the relief valve, check the venting, and confirm the gas connection with a leak test.
Code Compliance Check
We verify the install against the Uniform Plumbing Code and NFPA 54 for gas units. If your old setup was out of code, we bring it up to standard during the replacement.
System Test and Walkthrough
We fill the tank, bleed the lines, and run it until the water is hot. You get a walkthrough of the shutoff valve, the anode rod service schedule, and the warranty terms before we leave.
How it works
Our Replacement Process, Step by Step
We ask about the tank age, fuel type, and symptoms like leaking or no hot water. That tells us which unit to load and whether this is an emergency. You get a rough price range on the call, usually in under 10 minutes.
A licensed plumber checks the tank, venting, gas line or circuit, and shutoff valve. We confirm the size and code requirements, then give you the final price before any work starts. This takes about 15 to 20 minutes.
We shut off the supply, connect a water heater drain pump, and empty the tank. Old fittings come out with a tube cutter, and the unit is disconnected and hauled out. Expect 30 to 45 minutes for this stage.
We set the new tank, connect copper pipe or PEX tubing with brass fittings, and seal threads with Teflon tape and pipe dope. Gas flex connectors or electrical connections are made to code, and the expansion tank is charged to match your water pressure.
We fill the tank, bleed the lines, and fire it up. A multimeter checks the heating element on electric units, and we verify the T&P valve and venting. You get a walkthrough of the shutoff and warranty before we leave.
STEP 01Phone Assessment
We ask about the tank age, fuel type, and symptoms like leaking or no hot water. That tells us which unit to load and whether this is an emergency. You get a rough price range on the call, usually in under 10 minutes.
Tools & methods
Tools and Methods We Use
Pipe Wrench and Tube Cutter
Used to break loose old fittings and cut out corroded copper pipe cleanly. A clean cut means a better solder joint or PEX connection.
Soldering Torch and Flaring Tool
For copper pipe joints and gas line flares. We use the torch on copper repairs and the flaring tool on flexible gas connectors.
Water Heater Drain Pump
Empties the old tank fast without making a mess. Gravity draining a 50-gallon tank takes 20 minutes; the pump cuts that in half.
Multimeter and T&P Valve Tester
The multimeter checks heating elements and thermostats on electric units. The T&P tester confirms the relief valve opens at the correct pressure.
Expansion Tank and Dielectric Unions
An expansion tank absorbs pressure spikes from thermal expansion. Dielectric unions stop corrosion where copper meets the steel tank.
Real results
Before and after.
Residential Water Heater Replacement
Leaking 50-Gallon Tank in Hebron
A homeowner in Hebron called with water pooling around a 12-year-old tank. The bottom was rusted through, and the T&P valve was dripping. The family had been without hot water for a day.
After: We drained and removed the old unit, installed a new 50-gallon Rheem with fresh dielectric unions and an expansion tank, and had hot water running in three hours. The floor was dry before we left.
Book this service →
Residential Water Heater Replacement
No Hot Water in Castle Hills
A family of five in Castle Hills kept running out of hot water by the third shower. Their 40-gallon electric tank was 11 years old, and the lower heating element had failed. A repair quote was half the cost of a new unit.
After: We upgraded them to a 50-gallon unit with a higher recovery rate. The install took four hours, including a new expansion tank and a circuit check. They now get hot water through all five showers.
Book this service →
Residential Water Heater Replacement
Rusted Tank in Downtown Carrollton
A Downtown Carrollton homeowner noticed rusty hot water and a metallic taste. The tank was nine years old, and the anode rod was completely gone. Sediment had built up to the point where the tank popped loudly during heating cycles.
After: We replaced the tank with a new 40-gallon unit, flushed the hot water lines to clear the rust, and installed a fresh anode rod. The water ran clear within an hour of the swap.
Book this service → Problems we solve
Problems We Solve With Residential Water Heater Replacement
Most failing tanks give you warning signs before they quit. Here are the common problems Carrollton homeowners call us about, and how we fix them.
Ask a pro →Leaking tank flooding the floor
We shut off the supply, drain the tank, and replace the unit the same day. If water reached the drywall, we point out the damage so you can dry it out before mold sets in.
No hot water at any fixture
We diagnose the fault with a multimeter or by testing the pilot assembly. If the tank is past 10 years old, replacement usually costs less than repeated repairs.
Rusty or metallic-tasting hot water
We replace the corroded tank, flush the lines, and check your fixtures for sediment. A new anode rod and a flush schedule keep the next tank lasting longer.
Popping noises and sediment buildup
We drain and flush the tank to confirm the sediment level. If the buildup is heavy or the tank is old, we replace it and set you up with an annual flush routine.
Transparent pricing
What Residential Water Heater Replacement Costs
$900 - $1,800 installed, depending on tank size, fuel type, and code requirements
Typical 2026 pricing for a standard residential replacement in Carrollton runs $900 to $1,800 installed. A 40-gallon gas swap sits near the lower end, while tankless and hybrid units run higher because of venting and gas line changes. We quote the full price before we start, including the permit when one is required. If you are comparing a Carrollton GA residential water heater replacement, ask whether the quote includes removal, disposal, and a new T&P valve. Ours does.
The price covers removal, disposal, a new T&P valve, and a tested install. A failed tank can cause thousands in water damage, so replacing it on your schedule is the cheaper path.
•affects cost
A 40-gallon tank costs less than a 75-gallon or tankless unit. Larger tanks need more material and sometimes a gas line upgrade, which adds to the labor.
Get a quote ↗•affects cost
Gas replacements need a leak test and venting check. Electric swaps involve a circuit check and element testing. Both are straightforward, but gas jobs take slightly longer.
Get a quote ↗•affects cost
If your old install lacked an expansion tank, drain pan, or proper venting, we bring it up to code. That adds parts and labor but protects your warranty and your home.
Get a quote ↗•affects cost
A garage or basement tank is a quick swap. An attic or tight closet takes longer and may need a helper to maneuver the unit in and out.
Get a quote ↗ Proof you can check
Licensed, Insured, and Warranty-Backed
- Georgia Plumbing License · Georgia State Construction Industry Licensing Board
- Manufacturer Certification - Rheem · Rheem Manufacturing
- Manufacturer Certification - A. O. Smith · A. O. Smith Corporation
- Manufacturer Certification - Navien · Navien Inc.
- OSHA Safety Compliance · Occupational Safety and Health Administration
Customer reviews
What Carrollton Homeowners Say
★★★★★
“Our 12-year-old tank started leaking on a Friday morning. I called at 9 and had a new 50-gallon Rheem in by 2. The plumber showed me the old anode rod, which was completely gone. Clean work, no mess left behind, and the price matched the quote.”
MT
Marcus T.Homeowner, Downtown Carrollton
✓ Verified“
★★★★★
“We had no hot water for two days because another company kept rescheduling. These guys came out the same afternoon, found a failed heating element, and recommended a full replacement since the tank was 11 years old. Fair price and they hauled the old one away.”
DR
Dana R.Homeowner, Castle Hills
✓ Verified★★★★★
“I manage three rental units in Carrollton and needed a fast swap between tenants. They coordinated access, installed a new 40-gallon unit, and sent me the paperwork the same day. No tenant complaints since, and the water pressure is better than before.”
PS
Priya S.Landlord, Hebron
✓ VerifiedMost residential replacements in Carrollton run $900 to $1,800 installed, depending on tank size, fuel type, and whether code upgrades are needed. A standard 40-gallon gas swap sits near the lower end. Tankless and hybrid heat pump units cost more upfront but cut energy use. We give you the exact number on site before work begins.
We do. Our licensed plumbers cover all of Carrollton and Carroll County, including Downtown, Hebron, Castle Hills, and Valley Ranch. We handle gas, electric, tankless, and hybrid units. Call (943) 469-0029 and we will confirm availability for your address and get a truck headed your way.
A standard tank replacement takes two to four hours from arrival to hot water. Tankless conversions can run four to six hours because venting and gas line sizing often change. We give you a time window when we book the job and call ahead before we arrive.
Yes. A leaking tank or a gas smell gets priority dispatch, including nights and weekends. We can shut off the supply and isolate the unit to stop water damage, then return with the replacement. Call (943) 469-0029 and we will walk you through the shutoff while a plumber is on the way.
Ready when you are
Get Residential Water Heater Replacement in Carrollton Today
Cold showers end today. Call (943) 469-0029 and we will confirm a same-day window for your Carrollton address. Licensed plumbers, upfront pricing, and the old tank hauled away.
Call Now (943) 469-0029 →
Request an appointment
Call for Water Heater Help
Reach us at (943) 469-0029 any time, day or night. We answer live, ask a few questions about your tank, and get a plumber headed your way. Regular appointments run Monday through Friday, and emergency calls are covered 24/7 across Carrollton and Carroll County.
Call anytime(943) 469-0029Email the officeinfo@waterheaterreplacementcarrolltonga.xyz
Office hoursOpen 24 hours · 7 days a week