Old Tank Removal and Disposal
We drain the failed unit with a pump, disconnect the gas or power, and haul it out. Disposal is included, so you are not stuck with a 150-pound tank in the garage.
Same-day leaking water heater installation in Carrollton
Leaking Water Heater Replacement in Carrollton, GA
Leaking Water Heater Replacement in Carrollton is a same-day plumbing service that removes your failed tank, installs a code-correct replacement, and restores hot water the same visit. We handle gas and electric units, 40 through 75 gallons, for homeowners across Carroll County. If your tank is dripping, rusting, or tripping the T&P valve, call (943) 469-0029 and we will get a truck to your driveway.
Careful work. Honest options.
About this service
What Leaking Water Heater Replacement in Carrollton Involves
Leaking Water Heater Replacement in Carrollton is the full removal and re-installation of a failed tank, not a patch job. We kill the gas or power, drain the tank with a water heater drain pump, disconnect the dielectric unions and flexible connectors, and haul the old unit out. The new tank goes in with fresh Teflon tape, pipe dope, a new anode rod, and a T&P valve tested before we leave. Most swaps run two to four hours.
Carrollton homes take a beating from our water. Sediment buildup in the tank bottom eats steel, and the corroded anode rod that should protect the lining gives out years early. When the tank finally leaks, it usually happens at 2 a.m. or the night before a holiday. That is why we run emergency leaking water heater replacement Carrollton calls around the clock, and why a leaking water heater replacement near me search should end with a licensed local crew.
- ✓ Hot Water Back Today
- ✓ Stops Water Damage Cold
- ✓ Code-Correct From Day One
- ✓ Lower Bills, Longer Life
What's included
What Our Leaking Water Heater Replacement Includes
Every replacement includes the work below. If your setup needs something extra, like a new expansion tank or a venting upgrade, we tell you before we start and price it upfront.
New Tank and Fittings
Your replacement goes in with new dielectric unions, flexible connectors, brass fittings, Teflon tape, and pipe dope. We do not reuse old fittings that are already corroded.
T&P Valve and Expansion Tank Check
We test the temperature and pressure relief valve and replace it if it fails. If the expansion tank is waterlogged, we swap it during the same visit so the new heater is protected.
Code-Correct Venting and Gas Work
Gas connections follow NFPA 54, and venting meets Uniform Plumbing Code. We check the flue, the gas flex connector, and the draft so the unit burns clean and safe.
Fill, Purge, and Hot Water Test
We fill the tank, purge air from the lines, restore gas or power, and run hot water at the nearest fixture. You see it working before we leave the property.
How it works
How Our Replacement Process Works
You call (943) 469-0029 and describe the leak. We ask about the tank age, fuel type, and whether the leak is from the tank, the T&P valve, or a fitting. That tells us what to load on the truck before we roll.
We kill the gas valve or breaker, close the cold supply, and hook up the drain pump. A 50-gallon tank drains in about 15 minutes with the right pump. You will hear the tank empty and see the puddle stop growing.
Out comes the old unit. We check the shutoff valve, the gas flex connector, the venting, and the pan. If the expansion tank is waterlogged or the T&P valve is seized, we replace it now while the space is open.
The new water heater goes in level, strapped, and vented to code. We use new dielectric unions, brass fittings, and flexible connectors, then pressure-test every joint with a multimeter-checked element and a T&P valve tester.
We fill the tank, purge the air, light the pilot or restore power, and run hot water at the nearest fixture. You get a walkthrough of the thermostat setting, the anode rod schedule, and the warranty paperwork before we pack up.
STEP 01Call and Diagnose
You call (943) 469-0029 and describe the leak. We ask about the tank age, fuel type, and whether the leak is from the tank, the T&P valve, or a fitting. That tells us what to load on the truck before we roll.
Tools & methods
Tools and Methods We Use
Water heater drain pump
Empties a 50-gallon tank in about 15 minutes so we can move it without flooding your floor.
Pipe wrench and tube cutter
Breaks loose old unions and cuts copper or PEX cleanly for the new connections.
Soldering torch and flaring tool
Makes leak-free copper joints and flares for gas lines where the code requires them.
Multimeter and T&P valve tester
Verifies heating elements, thermostats, and relief valve operation before we call the job done.
Dielectric unions and flexible connectors
Prevents electrolysis between dissimilar metals and absorbs vibration on the new tank.
Real results
Before and after.
Leaking Water Heater Replacement
50-Gallon Tank Swap in Downtown Carrollton
A 13-year-old gas tank leaked from the bottom seam into a garage closet. The pan was rusted through, and the shutoff valve would not close fully.
After: We replaced the tank with a new 50-gallon Rheem, installed a fresh pan and drain line, and swapped the shutoff valve. Hot water was back in three hours.
Book this service →
Leaking Water Heater Replacement
Rusted Tank Replacement in North Carrollton
A rental property had rusty hot water and a slow leak at the drain valve. The tenant had been without reliable hot water for a week.
After: We installed a new 40-gallon A. O. Smith unit, replaced the corroded anode rod, and flushed the lines. The tenant had hot water the same afternoon.
Book this service →
Leaking Water Heater Replacement
Emergency Swap in Castle Hills
A family of five called at 6 a.m. after finding their 50-gallon tank leaking across the garage floor. They had no hot water and a swim meet that evening.
After: We drained the old tank, installed a new 50-gallon unit with a fresh expansion tank, and tested every joint. Hot water was restored by 11 a.m.
Book this service → Problems we solve
Leaking Tank Problems We Solve in Carrollton
A leaking water heater is rarely the only issue. Here are the problems we see on Carrollton calls and how we handle them.
Ask a pro →Tank leaking from the bottom seam
We shut the supply, drain the tank, and install a new unit the same day. The old tank is hauled off, and we set the new one in a pan with a routed drain line.
Rusty water and a corroded anode rod
We replace the tank and install a fresh anode rod. During the swap we flush the lines and check the dip tube so the new unit starts clean.
T&P valve dripping or stuck open
We replace the valve with the correct rating, test it with a T&P valve tester, and route the discharge line to code. If the expansion tank is bad, we swap it too.
No hot water after the tank started leaking
We replace the unit, test the heating element or burner with a multimeter, and confirm hot water at the tap before we leave. Same-day service is standard.
Transparent pricing
What Leaking Water Heater Replacement Costs
$850 - $1,800 installed, depending on tank size, fuel type, and code work needed
Typical 2026 pricing in Carrollton runs $850 to $1,800 installed for a standard tank replacement. That covers removal, disposal, new fittings, and code-correct venting. Tankless conversions, 75-gallon units, and jobs that need new venting or electrical work run higher. We quote the full price before we start, so there is no diagnostic fee stacked on top. If you are comparing a leaking water heater replacement company Carrollton GA, ask whether removal and disposal are included. With us, they are.
A leaking tank only gets worse. Replacing it now protects your floors, restores hot water, and comes with a manufacturer warranty on the unit plus our workmanship guarantee.
•affects cost
A 40-gallon electric tank costs less than a 75-gallon gas unit. Fuel type affects the fittings, venting, and labor needed for a code-correct install.
Get a quote ↗•affects cost
Older Carrollton homes often need new flue pipe or a power vent kit. We price that upfront so the final invoice matches the quote.
Get a quote ↗•affects cost
If the expansion tank is waterlogged or the T&P valve is seized, we replace them during the swap. It adds parts cost but protects the new heater.
Get a quote ↗•affects cost
A tank in a wide garage is faster to swap than one in a tight closet or attic. Difficult access adds labor time, and we tell you before we start.
Get a quote ↗ Proof you can check
Licensed, Insured, and Warrantied
- State Plumbing License · Georgia Secretary of State, Professional Licensing Boards
- Manufacturer Certification (Rheem, A. O. Smith, Navien) · Manufacturer training programs
- Uniform Plumbing Code (UPC) Compliance · International Association of Plumbing and Mechanical Officials
- NFPA 54 Gas Code Compliance · National Fire Protection Association
- OSHA Safety Compliance · Occupational Safety and Health Administration
Customer reviews
What Carrollton Customers Say
★★★★★
“Our 50-gallon tank let go on a Sunday night and flooded the garage. I called at 7 a.m. Monday and they had a new Rheem in by noon. They drained the old one, replaced the expansion tank, and tested everything. No hot water for six hours total. That is what I wanted.”
MT
Marcus T.Homeowner, Downtown Carrollton
✓ Verified“
★★★★★
“I manage three rentals near Belt Line and one had a leaking tank with tenants inside. They coordinated access, swapped the unit, and sent me the paperwork the same day. The price matched the quote exactly. I have used them twice since.”
DR
Dana R.Landlord, North Carrollton
✓ Verified★★★★★
“We had rusty water for weeks and then the tank started dripping. They showed me the corroded anode rod and explained why patching was pointless. Installed a new 50-gallon A. O. Smith, checked the T&P valve, and cleaned up the closet better than they found it.”
PS
Priya S.Homeowner, Castle Hills
✓ VerifiedMost replacements run $850 to $1,800 installed, depending on tank size, fuel type, and whether we are swapping a standard 40-gallon or upgrading to a 75-gallon or tankless unit. The cost to replace leaking water heater in Carrollton GA includes removal, disposal, new fittings, and code-correct venting. We quote the full price before we start.
We do. Carrollton Water Heater Replacement Pros is a state-licensed plumbing contractor based in Carrollton, Georgia, serving Carroll County and the 30117, 30116, and 30118 ZIP codes. We handle gas and electric tanks, power vent and direct vent models, and we carry common sizes on the truck for same-day service.
A standard swap takes two to four hours from arrival to hot water. That includes draining the old tank, installing the new unit, pressure-testing every joint, and purging air from the lines. Larger 75-gallon units or conversions to tankless can run a full day, and we tell you which one you are getting when we quote.
Yes. We run 24/7 emergency service for leaking tanks, no-hot-water calls, and gas or T&P valve failures. Call (943) 469-0029 any hour and we will dispatch a truck. If the leak is active, shut off the cold supply valve and the gas valve or breaker before we arrive.
Ready when you are
Get Leaking Water Heater Replacement in Carrollton Today
A leaking tank gets worse by the hour. Call (943) 469-0029 and we will dispatch a licensed tech with the right replacement on the truck. Upfront pricing, same-day service, and hot water back before we leave.
Call Now (943) 469-0029 →
Request an appointment
Call for Water Heater Help
Reach us at (943) 469-0029 any time, day or night. We answer live, ask a few questions about your tank, and get a plumber headed your way. Regular appointments run Monday through Friday, and emergency calls are covered 24/7 across Carrollton and Carroll County.
Call anytime(943) 469-0029Email the officeinfo@waterheaterreplacementcarrolltonga.xyz
Office hoursOpen 24 hours · 7 days a week