Shut-Off And Drain-Down
We kill the gas or power, confirm with a multimeter, and drain the tank using a hose or water heater drain pump. A 40-gallon unit drains in 10 to 15 minutes, and we handle the sediment that clogs most drain valves.
Water Heater Removal and Disposal Carrollton GA means the dead tank in your basement or garage is gone, the floor is dry, and the old unit is recycled instead of sitting on your curb. We handle water heater removal and haul away in Carrollton for homeowners in Carroll County who need the old unit out fast, whether it is leaking, rusted through, or just failed on a cold morning.

Water Heater Removal and Disposal Carrollton GA is the full tear-out of a failed tank or tankless unit: killing the gas or power, draining the tank, cutting the copper or PEX loose, and hauling the whole thing off your property. We shut the supply valve, open a hose to a drain or pump the tank with a water heater drain pump, break the dielectric unions, and walk the unit out. Nothing gets left in the yard, and nothing gets dumped in a Carrollton alley.
Most calls we run in Carrollton start the same way: rusty water, popping noises from sediment buildup, or a puddle spreading across the garage floor. A 40-gallon tank full of water weighs about 400 pounds, so dragging it out yourself is a back injury waiting to happen. If you are searching for water heater removal and disposal near me, we cover the whole city and can usually get a truck to you the same day you call.
Our standard removal covers everything needed to get a dead water heater off your property safely. Add-ons like replacement install, expansion tank swap, or T&P valve replacement are quoted separately, and we tell you which ones you actually need before we start.
We kill the gas or power, confirm with a multimeter, and drain the tank using a hose or water heater drain pump. A 40-gallon unit drains in 10 to 15 minutes, and we handle the sediment that clogs most drain valves.
Copper pipe or PEX tubing gets cut clean, dielectric unions come apart, and the gas line is capped to NFPA 54. If the shut-off valve is seized, we replace it while the area is already open.
The tank leaves your property on our truck and goes to a licensed recycling yard. Steel, brass fittings, and copper pipe are separated. You never deal with a scrap yard or a curbside pickup that will not take it.
We lay pads before we touch the tank, use rollers on stairs, and sweep the area after. Door frames, tile, and hardwood stay intact. You get the space back broom-clean, ready for the new unit or storage.
We text you a photo of the empty space and the disposal receipt on request. Landlords and property managers around Rosemeade and Josey Ranch use this for tenant files and insurance claims.
We ask the make, size, and location of the unit, plus whether it is gas or electric. That tells us which tools to load and whether we need a second tech for a tight basement or attic pull. You get a real price range before we roll, usually in under five minutes.
On arrival we kill the breaker or the gas valve, confirm with a multimeter, then hook up a hose or drain pump. A 40-gallon tank drains in about 10 to 15 minutes. If the drain valve is clogged with sediment, we pull the T&P valve and drain from the top instead.
We cut the copper pipe or PEX tubing with a tube cutter, break the dielectric unions, and cap the gas line per NFPA 54. Flexible connectors and brass fittings come off clean. If the shut-off valve is seized, we replace it while we are already in there.
The old tank goes up the stairs or out the garage door on pads and rollers. We lay down floor protection first, then sweep and wipe the area. Most removals take 45 to 90 minutes start to finish, and you never touch the tank.
The unit goes to a licensed recycling yard where the steel shell, brass, and copper are separated. We text you a photo of the empty space and the receipt if you need it for a landlord file or insurance claim. That closes the job.
We ask the make, size, and location of the unit, plus whether it is gas or electric. That tells us which tools to load and whether we need a second tech for a tight basement or attic pull. You get a real price range before we roll, usually in under five minutes.
Moves water out fast when the tank sits below a floor drain or the drain valve is clogged with sediment. Cuts drain time from 30 minutes to about 10.
Cuts copper pipe clean and forms flares for gas connections. A clean cut means fewer leaks and a faster reconnect if you are installing a new unit.
Breaks stubborn dielectric unions and solders new copper joints when we cap or reroute lines. Standard gear on every removal truck.
Confirms power is dead on electric units and checks the temperature and pressure relief valve on the new install. Safety step, not optional.
We inspect the expansion tank during removal and replace it if the bladder failed. Dielectric unions go on the new install to stop galvanic corrosion at the connections.
Seals threaded gas and water connections to code. We use both on every fitting so joints stay dry and pass inspection.

A 50-gallon Rheem in a Downtown Carrollton garage had been leaking for two days. The drain valve was clogged with sediment, the floor was wet, and the base of the tank had rusted through.
After: We pumped the tank dry, cut the copper loose, and had it on the truck in about 70 minutes. The floor was swept and dry, and the customer booked a same-day replacement install.
Book this service →
A failed electric unit sat in an attic closet with a narrow folding stair. The homeowner had already tried to move it and put a crack in the ceiling drywall.
After: We killed the breaker, confirmed dead with a multimeter, drained the tank to cut the weight, and pulled it with two techs and rollers. No new damage, and the closet was clean in 90 minutes.
Book this service →
A property manager had three dead tanks across two duplexes, all sitting in closets and blocking turnover. Tenants had been without hot water for over a week.
After: We removed all three in one trip, recycled them, and sent photos plus disposal receipts the same day. Two new units were set the following morning, and the third was scheduled around the tenant.
Book this service →A dead water heater is never just a dead water heater. It leaks, it rusts, it stinks, and it takes up space. Here are the problems we hear about most in Carrollton and how we close them out.
Ask a pro →We shut the supply, drain the tank, and haul it out the same visit. The area gets dried and we check the shut-off and expansion tank while we are there so the new install starts clean.
We confirm the tank is past saving, remove it, and recycle the shell. If you want a replacement, we can set a new unit the same day and check the dip tube and heating element on the new one.
We drain the tank first to cut the weight, pull the T&P valve if needed to make the turn, and use two techs with pads and rollers. Most tight-space removals are done in 90 minutes without a scratch.
We take it the same day, drained and disconnected, and recycle it at a licensed yard. You get the receipt on request, and the curb stays clean.
$150 - $450 for removal and disposal; $900 - $2,400 bundled with a new tank installed
Typical 2026 pricing for water heater removal and disposal in Carrollton runs $150 to $350 for a standard residential tank, including drain-down, disconnection, haul-off, and recycling. Tight attic or basement pulls with a second tech can reach $450. If we are installing a new unit on the same visit, the removal is usually bundled at a lower rate. We quote the full number before we start, and there is no fuel surcharge or stair fee tacked on after the fact.
You are paying for safe disconnection, heavy lifting, code-correct capping, and legal recycling, all in one visit. Doing it yourself means risking a back injury, a gas leak, or a tank that sits on the curb for weeks.
A 40-gallon tank is a one-tech job in most cases. A 75-gallon or commercial unit needs two techs and more time, which adds to the labor.
Get a quote ↗Garage and slab installs are the easiest. Attics, basements with narrow stairs, and tight closets add 15 to 30 minutes and sometimes a second tech.
Get a quote ↗Gas removals include capping the line to NFPA 54 and leak-testing. Electric removals need breaker lockout and a multimeter check. Both are included in the quote.
Get a quote ↗Seized shut-off valves and corroded dielectric unions take extra time to break free. We replace a failed valve on the spot rather than leave you with a problem.
Get a quote ↗“My 50-gallon Rheem let go on a Sunday and flooded half the garage. They came out the same afternoon, drained it, cut it loose, and had it on the truck in about an hour. Price was exactly what they quoted on the phone. No upsell, no mess left behind.”
Marcus T.Homeowner, Downtown Carrollton
✓ Verified“We manage several rentals and use them for every water heater removal and haul away in Carrollton. They coordinate with tenants, send photos of the empty closet, and the disposal paperwork is always in my inbox the same day. That reliability is why we stopped calling anyone else.”
Dana R.Property Manager, Trinity Mills
✓ Verified“Old tank was in a tight attic closet and I was sure it would damage the ceiling coming out. Two techs, pads on the stairs, and it was gone in 90 minutes. They even tested the T&P valve on the new unit before they left. Straightforward crew.”
Ellis W.Homeowner, Castle Hills
✓ VerifiedMost residential removals in Carrollton run $150 to $350 in 2026, including drain-down, haul-off, and recycling. A tight attic or basement pull with a second tech can push it to $450. If we are also installing a new unit, the removal is often bundled at a lower rate. You get the exact number before we start.
We do, and we cover all of Carrollton plus Carroll County. You can reach us at (943) 469-0029 for water heater removal and haul away in Carrollton. We are a licensed local plumbing crew, not a junk hauler, so we disconnect the gas or power safely and cap the lines to code before the tank leaves your property.
A standard 40 or 50-gallon tank takes 45 to 90 minutes from arrival to clean floor. Add 15 to 30 minutes if the unit is in an attic, a tight closet, or a basement with a narrow stair turn. Draining alone is 10 to 15 minutes. We schedule two-hour windows so you are not stuck waiting all day.
Yes, same-day service is available most weekdays when you call before noon. We keep removal slots open for emergency calls, including leaking tanks and no-hot-water situations. Weekend and after-hours emergency water heater removal and disposal Carrollton requests are handled too, with a straight after-hours rate quoted up front.
One call and the old unit is drained, disconnected, and on our truck. We are licensed, insured, and we quote the removal price before we start. Call (943) 469-0029 for Water Heater Removal and Disposal Carrollton GA and get your floor back.
Book Removal Now (943) 469-0029 →Reach us at (943) 469-0029 any time, day or night. We answer live, ask a few questions about your tank, and get a plumber headed your way. Regular appointments run Monday through Friday, and emergency calls are covered 24/7 across Carrollton and Carroll County.