Drain and Haul-Away
We pump out the old tank with a water heater drain pump, disconnect the gas or electrical supply, and remove the unit. The rusted shell leaves with us, so you are not stuck with a 150-pound piece of scrap.
Same-day tank swaps for corroded, leaking, rusty-water units
Rusted Water Heater Tank Replacement Carrollton GA
When your tank starts weeping rust or your hot water turns brown, Rusted Water Heater Tank Replacement Carrollton GA is the fix that stops the damage. We pull the corroded unit, inspect the connections, and set a new tank the same day across Carrollton, Georgia. Our licensed plumbers carry Rheem and A. O. Smith tanks on the truck, so you are not waiting a week for hot water.
Careful work. Honest options.
About this service
Rusted Water Heater Tank Replacement Carrollton GA
Rusted Water Heater Tank Replacement Carrollton GA is a plumbing service that removes a corroded steel tank and installs a new water heater before the rust turns into a flood. Rust inside a tank usually starts at the anode rod, then eats through the lining and the shell. Once you see orange water or a damp ring at the base, the tank is on borrowed time. We drain it, cut it loose, and set a new unit on fresh dielectric unions and flexible connectors.
Carrollton homes deal with hard water pulled from local wells and the municipal supply, and that mineral load speeds up sediment buildup and tank corrosion. If your water heater is over eight years old and popping, rumbling, or leaving rust streaks in the tub, call us before it lets go. We handle rusted water heater tank installation Carrollton Georgia for homeowners, landlords, and small commercial buildings, and we can usually get a truck to you the same day you call.
- ✓ Stop Rusty Hot Water
- ✓ Avoid Water Damage
- ✓ Cut the Gas Bill
- ✓ Restore Reliable Hot Water
What's included
What Our Rusted Tank Replacement Includes
Every rusted tank replacement includes the labor, parts, and cleanup to get you back to hot water. Here is what is covered in the quoted price, and what we only add if your setup needs it.
New Tank and Connections
Your new Rheem, A. O. Smith, or Bradford White tank comes with fresh dielectric unions, flexible connectors, Teflon tape, and pipe dope on the threads. We solder or crimp the copper pipe or PEX tubing to match your existing lines.
Safety Valve and Venting Check
We test the T&P valve, confirm the discharge line is clear, and inspect the venting on gas units. If the expansion tank is waterlogged, we can replace it during the same visit so the new tank is not over-pressurized.
Gas or Electrical Hookup
Gas tanks get a new gas flex connector and a leak test per NFPA 54. Electric tanks get the heating element and thermostat checked, and we verify the breaker and whip are sized correctly for the new unit.
Fill, Purge, and Test
We fill the tank, purge air from the lines, and run hot water until the temperature holds. You get a walkthrough of the shutoff valve, the anode rod schedule, and the warranty terms before we pack up.
How it works
How Our Replacement Process Works
You call (943) 469-0029 and describe what you are seeing: rust color, leak location, age of the tank. We ask for the model and fuel type, then quote a range before we roll. Most Carrollton calls get a same-day window, and emergencies get priority.
Our plumber checks the tank, the T&P valve, the anode rod, the gas flex connector or electrical whip, and the venting. We confirm the tank is truly rusted and not just a failed heating element. You get a firm price before any work starts.
We shut the water and fuel, hook up a water heater drain pump, and empty the tank. The old unit comes out with a tube cutter and pipe wrench, and we haul it away. Floor protection goes down first so your carpet and tile stay dry.
We set the new Rheem, A. O. Smith, or Bradford White tank, connect dielectric unions and flexible connectors, and solder or crimp the copper pipe or PEX tubing. Gas units get a new flex connector and a leak test per NFPA 54. Electric units get a fresh element and thermostat check.
We fill the tank, purge the air, light the pilot or power the element, and run hot water until the temperature holds steady. Then we walk you through the shutoff, the anode rod schedule, and the warranty. The whole visit runs three to five hours.
STEP 01Phone Diagnosis
You call (943) 469-0029 and describe what you are seeing: rust color, leak location, age of the tank. We ask for the model and fuel type, then quote a range before we roll. Most Carrollton calls get a same-day window, and emergencies get priority.
Tools & methods
Tools and Methods We Use
Water heater drain pump
Empties a 50-gallon tank in minutes instead of letting it gravity-drain for an hour. Less water on your floor, faster swap.
Pipe wrench and tube cutter
Breaks loose corroded unions and cuts copper pipe cleanly so the new connections seat without leaks.
Soldering torch and flaring tool
Sweats copper joints and forms flare fittings for gas lines. We match the method already used in your home.
Multimeter and T&P valve tester
Checks heating element continuity, thermostat function, and confirms the relief valve opens at the right pressure.
Dielectric unions and flexible connectors
Stop electrolysis between copper and steel, which is what eats tanks from the inside. Standard on every install.
Expansion tank
Absorbs thermal expansion so the T&P valve is not weeping. We replace waterlogged tanks during the swap.
Real results
Before and after.
Rusted Water Heater Tank Replacement
Rusted 50-Gallon Swap in Trinity Mills
A rental near Trinity Mills had an 11-year-old gas tank putting out brown water. The tenant reported rust stains in the tub and a damp ring at the base. The anode rod was completely consumed.
After: We installed a new 50-gallon Rheem tank with fresh dielectric unions and a new flex connector. Hot water ran clear within one cycle, and the old tank was hauled off the same day.
Book this service →
Rusted Water Heater Tank Replacement
Emergency Leak Fix in Downtown Carrollton
A rusted tank split at the seam overnight in a Downtown Carrollton bungalow. Water spread across the utility closet and into the hallway. The homeowner shut the inlet valve and called us at 7 a.m.
After: We arrived by 9 a.m., drained and removed the tank, and had a new 40-gallon unit installed and heating by early afternoon. The closet was dried and the discharge line was rerouted to code.
Book this service →
Rusted Water Heater Tank Replacement
Upgrade from Rusted Tank in Hebron
A Hebron family had a rusted 50-gallon electric tank with popping noises and slow recovery. The heating element was scaled and the thermostat was drifting.
After: We replaced the tank with a high-efficiency 50-gallon unit, installed a new expansion tank, and set the thermostat to 120 degrees Fahrenheit. Recovery time dropped from over an hour to about 25 minutes.
Book this service → Problems we solve
Rusted Tank Problems We Solve in Carrollton
Rust in a water heater shows up in a few predictable ways. Here is what Carrollton homeowners call us about, and what happens if you wait.
Ask a pro →Rust-colored hot water from every tap
We confirm the tank is the source, not the pipes, then swap the unit and flush the lines. Within one cycle your hot water runs clear again.
Water pooling at the base of the tank
We shut the inlet, drain the tank, and install a new unit with fresh connections. We check the drain pan and discharge line so the next failure, if it ever comes, stays contained.
Popping and rumbling during heat-up
We replace the tank and, if your water is especially hard, add a maintenance schedule for anode rod checks. A clean tank heats faster and lasts longer.
Pilot light keeps going out on a gas tank
We diagnose the burner and vent, then replace the rusted tank if the shell is compromised. Every gas job ends with a NFPA 54 leak test.
Transparent pricing
Rusted Tank Replacement Pricing
$850 - $1,800 installed, depending on tank size, fuel type, and code updates
Typical 2026 pricing for a rusted tank replacement in Carrollton runs $850 to $1,800 installed, depending on tank size, fuel type, and whether we need to update venting or add an expansion tank. A standard 40- or 50-gallon gas swap with haul-away usually lands in the middle of that range. Electric units run a bit less; tankless conversions run more because the gas line and venting change. We quote the full number before we start, and we do not add a separate disposal fee.
You are paying for a licensed install, code-correct venting, a new safety valve, and haul-away of the old tank. That is cheaper than a flooded floor and a mold remediation bill.
•affects cost
A 40-gallon electric tank costs less than a 75-gallon gas unit. Larger tanks need more material and, often, a second technician to set them safely.
Get a quote ↗•affects cost
If your old venting does not meet current UPC or IPC rules, we have to correct it. That adds parts and labor but keeps the install inspection-ready.
Get a quote ↗•affects cost
A waterlogged expansion tank or a stuck relief valve gets replaced during the swap. These are small parts, but they protect the new tank and your warranty.
Get a quote ↗•affects cost
A tank in a tight closet or attic takes longer to drain and remove than one in an open garage. Difficult access adds labor time to the job.
Get a quote ↗ Proof you can check
Licensed, Insured, and Reviewed
- Georgia Plumbing License · Georgia State Board of Examiners for Plumbers
- Uniform Plumbing Code (UPC) Compliance · International Association of Plumbing and Mechanical Officials
- NFPA 54 Gas Code Compliance · National Fire Protection Association
- Manufacturer Certification - Rheem · Rheem Manufacturing
- Manufacturer Certification - A. O. Smith · A. O. Smith Corporation
Customer reviews
Carrollton Customer Reviews
★★★★★
“My 11-year-old tank started putting out brown water on a Friday. They came out Saturday morning, confirmed the tank was rusted through, and had a new 50-gallon Rheem in by lunch. Hauled the old one off and even replaced the expansion tank. Hot water was back before my kids got home from soccer.”
MT
Marcus T.Homeowner, Downtown Carrollton
✓ Verified“
★★★★★
“I manage four rentals near Trinity Mills and one had a rusted tank leaking into the hallway. They handled the tenant, swapped the unit the same day, and sent me the invoice with photos. No drama, no repeat calls. I have used them twice since for other units.”
DR
Denise R.Landlord, Trinity Mills
✓ Verified★★★★★
“Called about popping noises and rust in the water. The plumber showed me the corroded anode rod and the sediment in the tank, then quoted a fair price for a Bradford White swap. Took about four hours. He tested the T&P valve and walked me through the shutoff before leaving.”
PW
Paul W.Homeowner, Hebron
✓ VerifiedMost Carrollton replacements run $850 to $1,800 installed, depending on tank size, fuel type, and whether we need to update venting or an expansion tank. A standard 50-gallon gas swap with haul-away sits near the middle of that range. Emergency after-hours calls add a dispatch fee. We quote the full number before we start.
We do. Carrollton Water Heater Replacement Pros handles rusted tank swaps across Carroll County, from Downtown Carrollton to Hebron and Valley Ranch. Our plumbers are state-licensed and manufacturer-certified on Rheem and A. O. Smith units. Call (943) 469-0029 and we will confirm a same-day or next-morning window.
A standard tank swap takes three to five hours from arrival to hot water. That covers draining, removal, new connections, filling, and testing. If we run into corroded shutoff valves or a venting issue, add an hour. Tankless conversions take longer, usually a full day, because the gas line and venting change.
Yes. If your rusted tank is leaking and you have water on the floor, call (943) 469-0029 and tell us. We prioritize active leaks and can often have a plumber out within a few hours. Shut the cold-water inlet and the gas valve or breaker before we arrive to limit the damage.
Ready when you are
Book Rusted Water Heater Tank Replacement Carrollton GA
Rusted tank leaking right now? Call (943) 469-0029 and we will get a licensed plumber headed your way. Same-day swaps, upfront pricing, and the old tank hauled off when we leave.
Call Now (943) 469-0029 →
Request an appointment
Call for Water Heater Help
Reach us at (943) 469-0029 any time, day or night. We answer live, ask a few questions about your tank, and get a plumber headed your way. Regular appointments run Monday through Friday, and emergency calls are covered 24/7 across Carrollton and Carroll County.
Call anytime(943) 469-0029Email the officeinfo@waterheaterreplacementcarrolltonga.xyz
Office hoursOpen 24 hours · 7 days a week