New Hybrid Unit
We supply a Rheem, A. O. Smith, or Navien hybrid heat pump water heater sized to your household. The unit comes with a 10-year tank warranty and 6-year parts coverage, and we register it for you the same day.
Licensed installers, same-day service, and upfront pricing across Carroll County
Hybrid Heat Pump Water Heater Replacement in Carrollton
When your old tank starts leaking or your hot water runs out mid-shower, our team handles Hybrid Heat Pump Water Heater Replacement in Carrollton from start to finish. We pull the permit, haul off the old unit, and set your new high-efficiency system the same day in most cases. Whether you need hybrid heat pump water heater installation in Carrollton for a home upgrade or an emergency swap, we keep the job clean, code-correct, and warrantied.
Careful work. Honest options.
About this service
What Hybrid Heat Pump Water Heater Replacement in Carrollton Involves
Hybrid Heat Pump Water Heater Replacement in Carrollton means removing your old electric or gas tank and installing a heat-pump unit that pulls warmth from the surrounding air to heat water. These systems use roughly 60% less electricity than a standard electric tank. We handle the full swap: drain and disconnect, new dielectric unions and flexible connectors, condensate routing, T&P valve testing, and a full pressure check before we leave your driveway.
Most Carrollton homes built before 2000 still run a 40- or 50-gallon electric tank tucked in a garage or utility closet. When that tank rusts out, you are looking at a flooded floor and no hot water. If you have been searching hybrid water heater replacement near me, we serve every ZIP from 30117 to 30116. We also handle same-day hybrid water heater installation Carrollton Georgia when the old unit fails without warning.
- ✓ Lower Power Bills
- ✓ Federal Tax Credit Eligible
- ✓ Built for Georgia Humidity
- ✓ Longer Tank Life
What's included
What Our Hybrid Replacement Service Covers
Every hybrid replacement includes the essentials: new unit, labor, permit, old tank disposal, and a full safety check. Here is what you get when we show up, plus a few add-ons we quote separately if your setup needs them.
Full Installation Labor
Our licensed plumber handles the disconnect, drain, removal, and new install. That includes dielectric unions, flexible connectors, brass fittings, Teflon tape, and pipe dope on every threaded joint. No shortcuts.
Permit and Inspection
We pull the Carroll County permit before work starts and coordinate the inspection afterward. Your install meets Uniform Plumbing Code and International Plumbing Code standards, including T&P valve and expansion tank requirements.
Condensate Management
Hybrid units produce condensate while they run. We route the drain line to a floor drain, utility sink, or condensate pump, and we test it before we leave so you never get a puddle under the unit.
Old Tank Haul-Away
We drain the old tank with a water heater drain pump, disconnect it, and haul it off for steel recycling. You do not need to move it, store it, or pay a separate disposal fee.
Safety and Leak Test
Before we pack up, we test the T&P valve with a T&P valve tester, check the anode rod, verify the thermostat settings, and inspect every joint for leaks. You get a walkthrough of the filter cleaning schedule and warranty terms.
How it works
Our Hybrid Water Heater Replacement Process
Call (943) 469-0029 and describe what you are seeing: leaking tank, rusty water, popping noises, or no hot water at all. We ask about your current unit size, fuel type, and location so we can load the right replacement on the truck before we roll.
A licensed plumber checks your existing setup: tank condition, T&P valve, expansion tank, venting, and electrical panel capacity. Hybrid units need a dedicated 240V circuit and about 700 cubic feet of air space, so we confirm the space works before quoting.
You get one clear price covering the new unit, labor, permit, haul-away, and any fittings or copper pipe needed. No surprise line items after the work starts. We walk you through the hybrid vs. standard electric difference so you can decide with real numbers.
We shut off the water and power, drain the old tank with a water heater drain pump, and disconnect the lines. The new hybrid goes in with brass fittings, Teflon tape, and dielectric unions to stop corrosion. Condensate lines get routed to a drain or pump.
We fill the tank, purge the air, test the T&P valve, and check for leaks at every joint. You get a walkthrough of the thermostat settings, filter cleaning schedule, and warranty registration. Most installs take three to five hours.
STEP 01Phone Assessment
Call (943) 469-0029 and describe what you are seeing: leaking tank, rusty water, popping noises, or no hot water at all. We ask about your current unit size, fuel type, and location so we can load the right replacement on the truck before we roll.
Tools & methods
Tools and Methods We Use
Water Heater Drain Pump
Pulls water out of the old tank fast so we are not waiting on gravity. Cuts removal time by 20 to 30 minutes on a standard 50-gallon unit.
Pipe Wrench and Tube Cutter
Used to break loose old fittings and cut copper pipe cleanly. We carry two sizes of pipe wrench for stubborn unions that have been in place for a decade or more.
Soldering Torch and Flaring Tool
For copper pipe connections and flare fittings on gas lines. We use these on every job that needs new pipe runs or a gas line cap.
Multimeter
Tests voltage at the breaker, the heating element, and the thermostat. Confirms the new hybrid unit is getting a clean 240V supply before we fill the tank.
T&P Valve Tester
Checks that the temperature and pressure relief valve opens at the rated setting. A stuck T&P valve is a safety hazard, so we test it on every install.
Dielectric Unions and Flexible Connectors
Stop galvanic corrosion between copper and steel connections. We install new ones on every swap, which protects the tank and the warranty.
Real results
Before and after.
Hybrid Heat Pump Water Heater Replacement
Leaking 50-Gallon Electric Tank Swap
A 12-year-old electric tank in a Downtown Carrollton garage was leaking from the bottom seam. The homeowner was mopping up water every morning and the power bill had climbed to $180 a month.
After: We installed a 50-gallon Rheem hybrid with a 65-gallon first-hour rating. The leak stopped, the floor dried out, and the first full month's power bill dropped to $128. Install took four hours.
Book this service →
Hybrid Heat Pump Water Heater Replacement
Gas Tank to Hybrid Conversion in Josey Ranch
A Josey Ranch home had a 15-year-old gas tank with a failing T&P valve and rusty water. The homeowner wanted to get off gas and lower utility costs.
After: We capped the gas line to NFPA 54, removed the old venting, ran a new 240V circuit, and installed a 65-gallon A. O. Smith hybrid. Water-heating cost dropped by about 58% the first month.
Book this service →
Hybrid Heat Pump Water Heater Replacement
Emergency Replacement for a Failed Element
A rental unit near Trinity Mills lost hot water on a Saturday morning. The tenant called, and the landlord needed it fixed before the weekend was over.
After: We diagnosed a failed heating element and a tank that was past 11 years old. The landlord approved a hybrid swap, and we had a new 50-gallon Rheem installed and running by 4 p.m. the same day.
Book this service → Problems we solve
Problems We Solve With Hybrid Water Heater Replacement
Most hybrid replacements start with a failing tank, but the reasons vary. Here are the common problems we see in Carrollton and how we fix them.
Ask a pro →Leaking tank flooding the garage floor
We shut off the supply, drain the tank with a water heater drain pump, and install a new hybrid unit the same day. We also check the T&P valve and expansion tank to make sure the new tank is not over-pressurized.
No hot water after a heating element fails
We test the element and thermostat with a multimeter on site. If the tank is past 10 years old, we recommend replacing it with a hybrid rather than sinking money into a failing unit. Same-day swap is usually possible.
Rusty water and popping noises from sediment
We confirm the tank is failing, then replace it with a hybrid unit that runs cooler and builds sediment slower. We also install a new anode rod and show you how to flush the tank yearly to protect the warranty.
High electric bills from an aging tank
A hybrid heat pump water heater cuts that cost by about 60%. We size the unit to your household, confirm the electrical panel can handle it, and install it with proper airflow clearance so it runs at rated efficiency.
Transparent pricing
Hybrid Water Heater Replacement Pricing
$1,800 - $3,200 installed, before federal tax credits
Typical 2026 pricing for a hybrid heat pump water heater replacement in Carrollton runs $1,800 to $3,200 installed. That range covers the unit, labor, permit, old tank disposal, and standard fittings. The low end is a straight swap in a garage with an existing 240V circuit. The high end includes electrical work, a relocation, or a larger 65- to 80-gallon unit. Federal tax credits can cover up to $2,000 of the total, which brings the net cost down significantly. We give you a flat quote before we start, so you know the number.
A hybrid unit uses about 60% less electricity than a standard electric tank, saving $300 to $450 a year in this area. With a 10-year tank warranty and up to $2,000 in federal tax credits, the math works for most Carrollton households.
•affects cost
A 50-gallon Rheem hybrid costs less than a 65- or 80-gallon A. O. Smith unit. Larger tanks hold more hot water but need more space and a stronger electrical supply. We quote both options so you can compare.
Get a quote ↗•affects cost
If your garage already has a dedicated 240V circuit, the install is straightforward. If we need to run a new circuit from the panel, that adds $300 to $700 depending on the run length and panel capacity.
Get a quote ↗•affects cost
Hybrid units need about 700 cubic feet of airflow. If your utility closet is too tight, we relocate the unit to the garage or basement and run new water lines and condensate routing. That adds labor and materials.
Get a quote ↗•affects cost
Switching from a gas tank to a hybrid means capping the old gas line to NFPA 54 and removing the venting. This is a code-required step and adds a few hundred dollars to the job.
Get a quote ↗ Proof you can check
Licensed, Certified, and Warrantied
- Georgia Plumbing License · Georgia State Board of Plumbing
- Rheem Manufacturer Certification · Rheem Manufacturing
- A. O. Smith Manufacturer Certification · A. O. Smith Corporation
- Navien Manufacturer Certification · Navien Inc.
- OSHA Safety Compliance · Occupational Safety and Health Administration
Customer reviews
What Carrollton Homeowners Say
★★★★★
“Our 12-year-old electric tank started leaking on a Friday morning. I called at 9 a.m. and by 3 p.m. we had a new Rheem hybrid installed and running. They pulled the permit, hauled off the old tank, and even showed me how to clean the filter. Power bill dropped about $40 the first month.”
MT
Marcus T.Homeowner, Downtown Carrollton
✓ Verified“
★★★★★
“I had three companies quote a hybrid install and these guys were the only ones who explained the airflow clearance issue in my utility closet. They ended up relocating the unit to the garage and it works great. No pressure, no upsell, just straight answers and a clean install.”
DR
Dana R.Homeowner, Josey Ranch
✓ Verified★★★★★
“I manage four rentals in Carrollton and have used these plumbers on two hybrid swaps. They coordinate with tenants, finish in under five hours, and send me the warranty paperwork the same day. The last tenant told me their electric bill dropped $35 a month. That is a real number.”
KM
Keith M.Landlord, Trinity Mills
✓ VerifiedMost hybrid replacements in Carrollton run $1,800 to $3,200 installed in 2026, depending on tank size, electrical work needed, and whether we are swapping a standard electric or gas unit. That covers the new heater, labor, permit, and haul-away. Federal tax credits can knock up to $2,000 off the total, so ask us for the paperwork.
Our licensed plumbers install hybrid heat pump units across Carrollton and Carroll County, including ZIP codes 30117, 30116, and 30118. We are manufacturer-certified on Rheem, A. O. Smith, and Navien systems, and we pull the local permit so the job passes inspection. Call (943) 469-0029 to schedule.
A standard swap takes three to five hours from arrival to walkthrough. If we need to run a new 240V circuit or reroute condensate lines, plan on a full day. Same-day hybrid water heater installation Carrollton Georgia is common when you call before noon and the space is already set up for a hybrid unit.
Yes, for most households of three or more people. A hybrid uses about 60% less electricity than a standard electric tank, saving $300 to $450 a year in this area. With a 10-year tank warranty and federal tax credits, the payback period is typically four to six years. Smaller homes with low hot-water use may not see the same return.
Ready when you are
Schedule Your Hybrid Heat Pump Water Heater Replacement in Carrollton
Call (943) 469-0029 and we will give you a flat price over the phone, then send a licensed plumber to your door. Same-day service, permit included, and a 2-year labor warranty on every Hybrid Heat Pump Water Heater Replacement in Carrollton we install.
Get Free Quote (943) 469-0029 →
Request an appointment
Call for Water Heater Help
Reach us at (943) 469-0029 any time, day or night. We answer live, ask a few questions about your tank, and get a plumber headed your way. Regular appointments run Monday through Friday, and emergency calls are covered 24/7 across Carrollton and Carroll County.
Call anytime(943) 469-0029Email the officeinfo@waterheaterreplacementcarrolltonga.xyz
Office hoursOpen 24 hours · 7 days a week